*
* NEC IX2215
* S/N : 56TNU08147
*
* ! No password
*
Copyright (c) NEC Corporation 2001-2015. All rights reserved.
%DIAG-INFO: Starting System POST(Power On Self Test)
DRAM TEST 1: Pass
DRAM TEST 2: Pass
NVRAM TEST: Pass
CPU TEST: Pass
PLD TEST: Pass
GE0 TEST: Pass
GE1 TEST: Pass
GE2(SW-HUB)1-8 TEST: Pass
BRI TEST: Pass
USB TEST: Pass
1.0 VOLTAGE STATUS: 0.987V Pass
1.5 VOLTAGE STATUS: 1.481V Pass
2.5 VOLTAGE STATUS: 2.457V Pass
3.3 VOLTAGE STATUS: 3.251V Pass
5.0 VOLTAGE STATUS: 4.940V Pass
TEMPERATURE STATUS: +25.0degC Pass
NEC Bootstrap Software
Copyright (c) NEC Corporation 2001-2015. All rights reserved.
NEC Bootstrap Software, Version 7.2
Copyright (c) NEC Corporation 2001-2015. All rights reserved.
boot[0]>
boot[0]> cc
Enter "Y" to clear startup configuration: Y
% Startup configuration is cleared.
NEC Bootstrap Software, Version 7.2
Copyright (c) NEC Corporation 2001-2015. All rights reserved.
boot[0]> b
NEC Bootstrap Software
Copyright (c) NEC Corporation 2001-2015. All rights reserved.
%BOOT-INFO: Trying flash load, exec-image [ix2215-ms-9.1.10.ldc].
Loading: ############################################################################### [OK]
Starting at 0x20000
Configuring router subsystems (before IDB proc): done.
Constructing IDB(Interface Database): done.
Configuring router subsystems (after IDB proc): done.
Initializing router subsystems: done.
Starting router subsystems: done.
All router subsystems coming up.
NEC Portable Internetwork Core Operating System Software
Copyright Notices:
Copyright (c) NEC Corporation 2001-2015. All rights reserved.
Copyright (c) 1985-1998 OpenROUTE Networks, Inc.
Copyright (c) 1984-1987, 1989 J. Noel Chiappa.
Router#
Router#
Router# config t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Router(config)# show flash
Codes: M - Main-side, B - Backup-side, N - Newfile, R - Runnable
A - Active-file, + - Next-boot, * - Bootmode-entry
Length Name Status
5154196 ix2215-ms-9.1.10.ldc MA
[5239360 bytes used, 21743234 available, 26982594 total]
26368 Kbytes of processor board System flash (Read/Write)
Router(config)#
Router(config)# show version
NEC Portable Internetwork Core Operating System Software
IX Series IX2215 (magellan-sec) Software, Version 9.1.10, RELEASE SOFTWARE
Compiled Feb 26-Thu-2015 10:26:18 JST #2 by sw-build, coregen-9.1(10)
ROM: System Bootstrap, Version 7.2
System Diagnostic, Version 7.2
Initialization Program, Version 7.1
System uptime is 0 minute
System woke up by reload, caused by power-on
System started at Sep 22-Mon-2025 14:30:35 JST
System image file is "ix2215-ms-9.1.10.ldc"
Processor board ID <0>
IX2215 (P1010E) processor with 262144K bytes of memory.
3 GigaEthernet/IEEE 802.3 interfaces
1 ISDN Basic Rate interface
1 USB interface
1024K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
Router(config)#
Router(config)# show environment
System hardware information:
Line voltage:
1.0 volt line not measured
1.5 volt line not measured
2.5 volt line not measured
3.3 volt line not measured
5.0 volt line not measured
Internal temperature:
Internal temperature not measured
Router(config)#
Router(config)#
Router(config)# show hardware
IX Series IX2215 Hardware Platform
S/N: 56TNU08147
Processor board:
Processor board ID <0>
CPU/DDR3/CSB/LBUS clock frequencies are 792/792/396/99 MHz
P1010E processor (revision 0x80f90010)
262144K bytes of main memory
1024K bytes of non-volatile configuration memory
32768K bytes of processor flash memory
IPsec accelerator:
on board security engine(SEC4.4), revision 0x100
Onboard interface unit GigaEthernet0:
GigaEthernet Transceiver is VSC8552
Onboard interface unit GigaEthernet1:
GigaEthernet Transceiver is VSC8552
Onboard interface unit GigaEthernet2:
GigaEthernet Switch with Transceivers is VSC7424
Onboard interface unit BRI0:
BRI Transceiver is YTD439
Router(config)#
Router(config)#
Router(config)# show license
IPsec H/W encryption is activated
ISDN-BRI/VRRP option is activated
Router(config)#
Router(config)# show vlans
GigaEthernet2 Virtual Bridged LAN
Group N/A status is down
Assigned ports: 1 2 3 4 5 6 7 8
0 input frames, 0 output frames
Router(config)#
Router(config)#
Router(config)# show error-log
Latest Occurrence Time Event Description
2015/06/24 11:56:16 +0900 INFO: Start logging fault and crash errorlog_information
2025/09/22 14:30:21 +0900 INFO: Start bootstrap from this side [0].
2015/08/26 12:00:54 +0900 INFO: Modify startup-config cmd:write state:succeeded from:smbc@local
2025/09/22 14:30:20 +0900 INFO: Erase startup-config cmd:cc state:succeeded from:@local
Router(config)#
Router(config)#
Router(config)# show crashinfo
Latest Occurrence Time Event Description
2015/06/24 11:56:16 +0900 INFO: Start logging fault and crash errorlog_information
2025/09/22 14:30:21 +0900 INFO: Start bootstrap from this side [0].
2015/08/26 12:00:54 +0900 INFO: Modify startup-config cmd:write state:succeeded from:smbc@local
2025/09/22 14:30:20 +0900 INFO: Erase startup-config cmd:cc state:succeeded from:@local
Router(config)#
Router(config)#
Router(config)# show config
% Non-volatile configuration memory is not present
Router(config)#
Router(config)#
Router(config)# show log
% Buffer logging disabled.
Router(config)#
Router(config)# exit
Router#